|
|
|
Flexible Stainless Steel Corrugated Water Connectors
Often imitated, never equaled
Water Dealer Specifications: Parts, Connectors: Clack Bypass
Caution: When connecting to a copper male adaptor or brass nipple, make sure to file any sharp edges which may contact and damage washer causing leaks.
We recommend the use of Dow 111 or similar, non-toxic silicone based lubricant on washers for all installations.
Note: Manufacturer assumes no responsibility for failure due to improper installation.
Corrugated Stainless Steel Flexible QC* Connectors for
Clack Bypass....fits Clack 1" and 1-1/4" Valves and bypass
H E R E FOR PDF SPECIFICATION SHEET FOR CLACK
requires Clack nut, split-ring and o-ring shown above
| SPECIFICATION: | COMPLIANCES/LISTINGS: |
|
|---|
Furnish and install Corrugated Stainless Steel
Connectors for CLACK bypass
*Clack QC (quick connect) ends plug directly into Clack bypass. Clack nut, clip and O-ring from tailpiece assembly required.
|
ICC-ES PMG
ICC Listed, Tested & Certified
UPC, IPC, IMC, IRC USA
Low Lead Compliant CA Health & Safety Code 116875
ASME A112.18.6/CSA B125.6-2009 compliant
NSF-61 (ICC-ES PMG Certified to ANSI/NSF sec 9)
Additional listings: State of Wisconsin, Commonwealth of Massachusetts, City of Los Angeles |
|
- DESIGN FEATURES: Mega-flow SUPER Water-flexTM
- 304 Series Stainless Steel
- Maintains optimum flow – No Restriction
- Kink and Crimp Free
- Chrome plated brass ends
- Extremely Flexible
- Will not corrode or rust
- No Dielectric union required
- Highest Quality EPDM washer
- Resists work hardening
- Working pressure 200 psi
- Burst pressure 1850 psi
- 100% Leak Tested
- Limited Lifetime Warranty
- Temperature rating 33 – 250 degrees F
- Easy Installation
|
Model # Description Length
ClackQC34 ClackQC x ¾” FIP 18”
ClackQC1 ClackQC x 1” FIP 18, 24"
ClackQCQC ClackQC x QC 18, 24”
Split Ring, O Ring and Nylon Nut provided by Clack Corp
|
|
 |
|
|
CLICK HERE FOR PDF SPEC SHEET
|
|
|
|
|